Save And Repeat Anumber - NEC Univerge SV9300 Series User Manual

SAVE AND REPEAT A
NUMBER
This feature allows a terminal to save a specific
dialed number and then redial that number.
This feature is set by Soft key or feature key.
The feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
Up to three Save and Repeat feature keys
can be assigned per terminal.
TO SET SAVE AND REPEAT
1. Dial the desired number and press
Soft key (S&R) or Save and Repeat
feature key.
HOW TO DIAL BY SAVE AND
REPEAT
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
Line key lamp lights green. →
4:26 PM MON 11 MAY 2015
Recall PICK
2. Save and Repeat feature key.
The terminal automatically redials the
programmed number.
Example: "201" is programmed number.
4:26 PM MON 11 MAY 2015
Recall VOICE
200
>>>>
201
CB >>>>
3. Lift the handset to start a
conversation.
Speaker key lamp goes off. →
4:26 PM MON 11 MAY 2015
MIC
Redialing the same number is possible until
new number is registered by this feature.
69
FEATURE OPERATION
201
Mute