HP T2touch PANEL Service Manual page 10

Step 5
(Knob Motor CW (Tumble CCW) -Motor
Position stops
5)
Step 6
(Knob Check Heater NTC if heater NTC
Position T=255
6)
Step 7
(Knob Check Door NTC if heater NTC
Position T=255
7)
Step 8
Compressor OFF- Motor CCW
(Knob
(Tumble CW) OFF- Cooling fan
Position
ON
8)
Step 9
(Knob Compressor ON- Motor CCW
Position (Tumble CW) -motor off
9)
Step 9
(Knob Check conductivity sensor when
Position door is opened and motor is off
9)
Remove
the last
error
(Knob
Position
1)
HP T2touch PANEL
SERVICE MANUAL
10
-
sec
5 sec E05
5 sec E06
10
-
sec
10
-
sec
5 sec E01
5 sec
DEL
CUSTOMER
SUPPORT
Service must check
whether tumble is
moving to CCW
-
*If tumble is moving to
CW again, then motor
relay short circuit CCW
*Heater NTC connector
- is taken out or short
circuit
*Door NTC connector is
-
taken out or short circuit
Service must check
power of at the home
- voltage and fan will be
controlled manually by
technical service.
Service must check
- power of at the home
voltage.
Service puts his hand on
the humidity sensor
plates and software
- checks sensor data
*If sensor data=0,
humidity sensor
connector is taken out
When the knop
DL is visualized
positioned to program 1,
on display and
service will pust the
make fast blink
both SW4 and SW5 for
for 2 sec for
T0/T1 (child lock mode).
T0.DEL is
When the knop
visualized on
positioned to program 1,
display and
service will pust the
make fast blink
both SW2 and SW3 for
for 2 sec
T2 (child lock mode).