Component Specifications And Measurements; Motor - HP T2touch PANEL Service Manual

7. 7. COMPONENT SPECIFICATIONS AND MEASUREMENTS

7.1. Motor

The dryer has an asynchronous motor. In
the photo on the right, the socket on the
motor are shown to be measured by
multiple counters. It is driven with triac via
the electronic card (to give energy) and
relay (for direction control).
Type: single-phase asynchronous motor
Power: 200 W (Unloaded drum)
Main windings: 21.5±7% (20 °C temp.)
Aux windings: 19.5±7% (20 °C temp.)
 Check whether the motor cable is connected to the motor connector.
 Check the connection of the capacitor cables
 Measure the resistance values and check the capacitor values
 Check whether it is working by connecting via the terminals 1 and 2 (Blue-White)
connection
 If it is working, revolution of the drum is measured in unloaded state.
The terminals 1-3 of the motor should be connected with capacitor
Resistance measurement of main winding: Terminal 1 -2 (Blue-White) is measured.
Resistance measurement of aux winding: Terminal 3 -2 (Red-White) is measured.
HP T2touch PANEL
SERVICE MANUAL
Technical Features
Motor speed : 2750 rpm (Unloaded drum)
Drum speed : 52 ± 2
Capacitor value : 11 µF ± %5
Component Test
CUSTOMER
SUPPORT