Silvercrest SEMK 105 B2 Operating Instructions And Safety Instructions page 9

General safety instructions
DANGER: Risk of electric shock
• The ice cube maker should only be used in dry, indoor areas.
• The power cable (10) must not be damaged. Never replace
a damaged power cable (10), instead contact our hotline.
There is a risk of electric shock in the case of a damaged
power cable (10).
• If the power cable of this device is damaged, it must be
replaced by the manufacturer, its customer service or a
similarly qualified person, in order to avoid any possible
danger.
• Never open the housing of the ice cube maker as there are
no components inside which require maintenance. Opening
the housing can expose you to the risk of electric shock.
• If you notice any smoke, unusual noises or strange smells,
switch the ice cube maker off immediately and disconnect the
mains plug from the socket. If this occurs, the ice cube maker
should not be used before it has been inspected by
authorised service personnel. Never inhale smoke from a
possible device fire. If you do inadvertently inhale smoke,
seek medical attention. Smoke inhalation can be damaging
to your health.
• Make sure that the power cable (10) cannot be damaged by
sharp edges or hot spots.
• Make sure that the power cable (10) cannot become
crushed or squashed.
• The ice cube maker must always be disconnected from the
mains when left unsupervised and before assembly,
disassembly or cleaning.
SilverCrest SEMK 105 B2
English - 7