Wall Mount - Sony SNC-HMX70 Installation Manual

Attach the camera body
1
Insert the Ethernet cable into the RJ45 connector on
the back of the camera.
2
Mount the slots on the back of the camera onto the
studs of the mounting ring.
3
Rotate the camera body clockwise until it clicks into
place.
1
RJ45
Mounting with a Surface Mount Box
To mount the camera using a Surface Mount Box (SMB):
1
Use the SMB to mark out the cable hole (if required)
and to mark the three mounting holes.
The PCD is 123 mm (4 7/8 in).
2
Drill three holes with a diameter of 6 mm (1/4 in).
3
Insert the supplied mounting plugs (6  30) into the
holes.
4
Use the supplied screws (4.5  40) to securely attach
the SMB to the surface:
5
Use the four screws (M5) to attach the mounting ring
to the SMB.
N
W
E
S
2
3
6
Attach the camera body to the mounting ring as
described above.
9.5 mm (3/8)
M5

Wall mount

Use the Surface mount box (SMB) to mount the camera on
a wall as described above. It is however, very important to
pay attention to the following points:
– Ensure that the SMB is mounted in one of the four 90°
rotation positions and that it is horizontal along the axes
shown. (Use the slots as a reference.)
– When attaching the mounting ring, ensure that the N is
at the top.
6
3
6 mm
4.5  4 (3)