Advertisement
Audio Dubbing
You can record a new soundtrack on a prerecorded
tape (normal audio only). The sound is recorded
from the built-in microphone.
Perform steps 1) and 2) of the Insert Editing
procedure (
pg. 26).
T
3) Press REW
to go a little beyond the beginning
of the scene onto which you want to dub the new
audio, press PLAY
then press PAUSE
dubbing should start.
4) While holding down A. DUB
a
release PAUSE
5) To begin Audio Dubbing, press PLAY
the counter reaches "0:00:00", Audio Dubbing
stops automatically and the camcorder enters
the Audio Dub-Standby mode. To end Audio
Dubbing, press STOP
• Do not press REW
Standby, or the edit points will not be accurate.
• If the microphone is too close to the TV, or if the
TV's volume is too high, whistling or howling may
occur.
For Insert Editing/Audio Dubbing
• Insert Editing and Audio Dubbing may not work
correctly if the tape contains blank segments, or if
the recording speed was changed during the
original recording.
• To edit/dub onto a tape, make sure the erase
protection tab is in the position that allows
recording.
• Do not press STOP
Audio Dubbing, or the edit points will not be
accurate.
R
to view the recorded tape,
a
at exactly the point where
s
, press and
.
R
Y
.
T
P
or FF
during Audio Dub-
Y
during Insert Editing or
. When
27
Advertisement
