AEG BE7004001 User Manual page 12

12 www.aeg.com
Clock function
7.2 Count Up Timer
The Count Up Timer is not
activated if Duration and
End are set.
The Count Up Timer starts to count when
the appliance starts to heat.
1. To reset the Count Up Timer, touch
again and again until
the display.
2. Touch
"00:00" and the Count Up Timer
starts to count up again.
7.3 Setting the DURATION
1. Activate the appliance and set an
oven function and temperature.
2. Touch
display shows
flashes in the display.
3. Use
DURATION.
4. Touch
5. Use
DURATION.
If you touch
while you set the
DURATION, the
appliance switches to
the setting of the END
function.
6. When the set time ends, an acoustic
signal sounds for two minutes.
TIME OF DAY
DURATION
END
SET+GO
until the display shows
again and again until the
.
or to set the minutes for
to confirm.
or to set the hours for
or
Application
To show the time of day. To change the time of day, re-
fer to "Setting the time".
To set how long the appliance operates.
To set when the appliance deactivates. You can use Du-
ration and End at the same time (Time delay) if you want
the appliance to activate and deactivate automatically
later.
To start the appliance with necessary settings with only
one touch of the sensor field any time later.
and time setting flash in the display.
The appliance deactivates.
7. Touch a sensor field or open the
oven door to stop the acoustic
signal.
8. Deactivate the appliance.
7.4 Setting the END
1. Activate the appliance and set an
flashes in
oven function and temperature.
2. Touch
display shows
flashes in the display.
3. Use
minutes and then the hours.
When the set time ends, an acoustic
signal sounds for two minutes.
and the time setting flash in the display.
The appliance deactivates.
4. Touch a sensor field or open the
oven door to stop the acoustic
signal.
5. Deactivate the appliance.
7.5 Setting the SET+GO
You can use the SET+GO function only
when the DURATION is set.
1. Set an oven function (or a
programme) and temperature (refer
again and again until the
.
or to set the END and
or to confirm. First you set the
symbol