Connecting The Magnetic Antenna Assembly (Optional); Installing The Magnetic Mount Antenna Assembly; Procedure - Motorola WMC7300715 User Manual

Pull straight out at the connector to avoid damaging the card, connector or cable.
2

Connecting the Magnetic Antenna Assembly (Optional)

Complete the following procedure to install the Magnetic Mount Antenna on the rooftop of a vehicle.
The length of the Antenna cable is approximately 12 feet.
It is recommended that you use an (optional) N-Type SMA to MMCX adapter with your antenna
cable, and then connect the MMCX directly to the card.

Procedure 3-3

Installing the Magnetic Mount Antenna Assembly

The graphic below depicts the Magnetic Mount Antenna Cable with antenna (Circle C), the MMCX
1
adapter, and the WMC6300 card. Circles A and B designate the required cable connection points.
Figure 3-2
A
Attach the Magnetic Antenna (shown in Circle C, Figure 3-2) to the metal rooftop of the vehicle so that
2
the antenna is in a vertical orientation.
Route the remaining 12 foot cable, (with the connected adapter cable and the WMC card) as required, to
3
arrive at the Host Computer.
6881011Y52-D January 2007
result in excess pressure being applied to the connection between
the WMC connector and the board, which could crack or otherwise
damage a solder joint.
Magnetic Mount Antenna, N-Type SMA to MMCX adapter, and WMC6300
The base of the antenna contains a powerful magnet that secures
the antenna to the rooftop. Use care when attaching the antenna.
MOTOMESH 1.2 Wireless Modem Card Users Guide
C
B
3-3
Magnetic Mount
Antenna Cable
WMC6300
Card
N-Type SMA to
MMCX adapter