Chapter 4: MeshTray
Geo Position Tab
If your Wireless Modem Card has been licensed for Geo-Location, an optional Geo Position tab will
be displayed as shown in the figure below. For the parameters to be enabled (not grayed-out), the
Display Geographic Position checkbox needs to be selected in the Configuration tab.
Figure 4-9
MeshTray Routing Tab
The MeshTray Routing Tab contains data pertaining to the local Subscriber Device and associated
Routing and Neighbor table information. The Threshold setting can be set to a minimum of -100 dBm.
Although the first two digits of the QDMA Transceiver MAC address on the label
for a Subscriber Device (WMC) may read 00, due to the operational requirements
of a MOTOMESH network, the Routing and Neighbor tables in MeshTray will
display 02 for the first two digits (local bit set) for all QDMA Transceivers devices.
When adding WMC devices to the network through MeshManager, 02 must be
used for the first two digits of the MAC address to be able to successfully manage
the device. Refer to the MeshManager Users Guide for details on adding devices
to the network.
6881011Y52-D January 2007
MeshTray Geo Position Tab
4-12