Panasonic AJ-PG50EJ Operating Instructions Manual page 64

Writing back (importing) data from a stor-
age device to a P2 card
 Importing data from a TYPE S storage device by
partition
You can import data (on a P2 card basis) to a P2 card with the
same model number as the source card (write back data from
a storage device to a P2 card) by partition.
1.
Insert the import destination P2 card.
Be sure to insert a formatted P2 card.
2.
Connect a storage device.
3.
Select "STORAGE" in the "EXPLORE" (➝ page 93)
menu item to display the EXPLORE screen.
4.
Display the thumbnails of the partition to be imported
in the EXPLORE screen.
5.
Select the "IMPORT" (➝ page 93) menu item.
6.
Align the cursor with the P2 card slot number that is
the import destination and press the [SET] button.
Select "YES" in the confirmation message to begin import-
ing.
When importing is completed, the "COPY COMPLETED!"
message appears.
Note:
• When data is imported to a P2 card that differs from the orig-
inal P2 card, some clips may become incomplete (display
the incomplete indicator). Should this happen, use the re-
connection function to rebuild the clips.
(➝ "Reconnecting incomplete clips" page 49)
• You can select whether to perform verification at the time of
copying in the "VERIFY" (➝ page 96) menu item.
• It is not possible to import data by partition to P2 cards with
different model numbers. Copy the data on a clip basis.
64
Main Mode: Thumbnail Screen
 Copying to a P2 card by clip
You can specify a clip on a storage device and copy it to a P2
card.
1.
Display the thumbnail screen of the storage device.
2.
Select a clip to copy.
3.
Press the [MENU] button.
4.
Align the cursor with the copy destination in the list of
the "COPY" (➝ page 93) menu item and press the
[SET] button.
Select "YES" in the confirmation message to begin copy-
ing.
When copying is completed, the "COPY COMPLETED!"
message appears.