Intended Use; Installing And Removing The Battery Pack - DeWalt DCE531 Instruction Manual

English
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.

Intended Use

This cordless pencil vibrator is designed for professional
vibration applications.
DO nOT use under wet conditions or in the presence of
flammable liquids, gases, or dusts.
This cordless pencil vibrator is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Attaching the Shaft (D, E)
1. Ensure that the plastic collar
shaft casing 6 as shown in Figure D.
2. Insert the spindle 9 into the flex shaft opening.
3. Manuevre the flex shaft back and forth until the parts
slide together (Fig. E).
4. Ensure that the flex shaft flange
housing .
3
5. Firmly tighten the collar by hand (Fig. E). Do not use a
wrench to tighten.
Fig. D
3
Fig. E
8
is inserted over the flex
7
10 is snug against
6
7
10
9
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

Installing and Removing the Battery Pack

(Fig. F)
nOTE: For best results, make sure your battery pack is
fully charged.
Fig. F
8
To install the battery pack 8
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 9 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Proper Hand Position (Fig. G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
and one hand on the main housing for stability.
Fig. G
Trigger Switch (Fig. A)
To turn the tool "ON", squeeze the trigger switch
the tool "OFF" release the trigger switch.
Lock-Off Button (Fig. H)
To select Locked/Off, depress the lock-off button
left side of the tool. When changing the position of the lock-
off button, be sure the trigger is released.
9
into the tool handle, align the
1 . To turn
on the
2