Speaker System Connection - LG LH-W360SE Manual

Speaker System Connection

Connect the speakers to the front (right, left) or
center speaker connectors at the main set.
Connect the subwoofer to the woofer connector.
Connect the power cord of the Wireless RX to the
outlet, then connect the Wireless RX and the rear
speaker (right, left) with the speaker cable.
Connect the DC IN connector of the Wireless TX
and the Wireless TX (DC 7V OUT) connector at the
main set with the DC power cable.
Connect the SOUND SIGNAL connector of the
Wireless TX and rear (right, left) speaker of
connectors of the main set with the sound signal
cable.
Set the distance between this unit and Wireless RX
within 10m.
Wireless TX
SIGNAL ID./CH. DC IN
Sound signal
cable
DC power cable
Rear speaker
(Right)
About Ferrite Core (OPTIONAL)
Be sure to attach the ferrite core to the speaker cables (for
connecting to this unit).
This ferrite core can reduce noises.
How to attach the ferrite core
1 Press the stopper [a] of the ferrite core to open.
2 Wind the cable once on the ferrite core.
3 Close the ferrite core unitl it clicks.
Note:
Attach the ferrite core near the unit (Refer to the fig.3 and
comment.).
Notes:
Center
Front speaker
speaker
(Right)
Red
Black
Subwoofer
Wireless RX
Optimum performance can be implemented only when the
Wireless TX and the Wireless RX within distance of 2m to
10m is used since communication failure may occur if
longer distance is used.
Be sure to match the speaker cable to the appropriate
terminal on the components: + to + and – to –. If the
cables are reversed, the sound will be distorted and will
lack base.
It takes about a few seconds (and may take longer) for the
Wireless TX and Wireless RX to communicate with each
other.
When the unit is turned off, the Wireless RX is in standby
mode (off) automatically after about 10 seconds.
If the Wireless RX is turned off, the wireless speaker will
not function.
Front speaker
(Left)
L
AUDIO
R
Rear speaker
(Left)
The length
here is as
short as
possible.
80mm
9