Wall Mount Installation - Bosch Photobeam 5000 Installation And Operation Manual

12 en | Installation
Caution!
Ensure that the pole mount installation is secure and stable. Failure to do so may result in
!
personal injury, or damage the device.
3.3

Wall mount installation

Installing the transmitter and receiver:
1. Remove the cover and mounting plate from the transmitter.
2. Route the wire through the mounting plate wire entry if the wire is routed through a wall
opening. If the wire is routed on the wall surface, knock-out the thin wall wire hole at the
bottom of the transmitter and cover. Route the wire through the opening after the
mounting plate is secured onto the wall.
3. Secure the mounting plate to the wall surface.
4. Route the wire through the detector wire entry location.
5. Secure the transmitter to the mounting plate.
6. Wire to the terminal strips. Refer to Wiring for wiring procedures.
7. Repeat this procedure for mounting the receiver.
1
Figure 3.5: Wall mount installation
Callout ー Description
1 ー Mounting screws
2 ー Mounting plate
3 ー Detector
2016.02 | 03 | F.01U.303.478
2
6
5
Installation and Operation Guide
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
3
4
Callout ー Description
4 ー Device securing screws
5 ー Knockout
6 ー Wire entry
Photobeam 5000
Bosch Security Systems, Inc.