Table of Contents
Advertisement
Photobeam 5000
8
Optical alignment
Perform the following to align the detector.
8.1
Level LED – alignment of the Upper Beam
Perform the following to align the upper beam.
Aligning of the upper beam:
1. Turn on the receiver Function switch 6. The monitor LED flashes (5 times/sec).
2. Look into the scope at the center of the lens from a 10-15 cm (4-5 in) distance, adjust the
horizontal direction by rotating the turntable and the horizontal adjustment screw. Adjust
the vertical direction by rotating the vertical adjustment screw. Adjust until you locate the
other part of the sensor in the center of the scope view.
3. Check the level LED of the receiver. Perform fine adjustments and repeat procedure until
the level LED turns off. Refer to Volt meter alignment, page 36.
1
2
Figure 8.1: Optical alignment
Callout ﹘ Description
1 ー Turntable
2 ー Vertical adjustment screw
3 ー Horizontal adjustment screw
Notice!
Turn on Function switches 1 and 2 of the transmitter after finishing the alignment to verify the
monitor LEDs light up once every 3 seconds.
8.2
Level LED - alignment of the Lower Beam
Perform the following to align the lower beam.
Aligning of the lower beam:
Bosch Security Systems, Inc.
3
Installation and Operation Guide
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
5
4
Callout ﹘ Description
4 ー Scope view finder
5 ー Dip switch
Optical alignment | en
35
2016.02 | 03 | F.01U.303.478
Advertisement
Table of Contents
