Panasonic FZ-E1 Series Operating Instructions Manual page 19

party responsible for compliance could void the user's authority to
operate this equipment.
This product complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This product may not cause harmful interference, and
2. This product must accept any interference received, including
interference that may cause undesired operation.
FCC RF exposure information
This product meets the government's requirements for exposure to
radio waves. This product is a radio transmitter and receiver.
This product is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the U.S. Government.
The guidelines are based on standards that were developed by
independent scientific organization through periodic and thorough
evaluation of scientific studies.
The standards include a substantial safety margin designed to
assure the safety of all persons, regardless of age and health.
The exposure standard for wireless handsets employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6 W/kg.
The tests are performed in positions and locations (e.g., at the ear
and worn on the body) as required by the FCC for each model.
The highest SAR value for this product as reported to the FCC when
tested for use at the ear is 0.105 W/kg, and when worn on the body
in a holder or carry case, is 0.530 W/kg.
For body-worn operation, this product has been tested and meets
FCC RF exposure guidelines when used with a Panasonic accessory
designated for this product and when used with an accessory that
contains no metal and that positions the mobile device a minimum of
1.0 cm from the body.
Use of other accessories may not ensure compliance with FCC RF
exposure guidelines.
Introduction 19