Panasonic FZ-E1 Series Operating Instructions Manual page 48

The screen is too dark.
• The [Automatically adjust] setting reduced the brightness
according to the ambient brightness. Manually adjust the screen
brightness.
1. Flick the Start screen to the left, and then in the App list, tap
[Settings] → [brightness].
2. Turn off the [Automatically adjust] switch.
3. Tap [Level] and select the desired brightness level.
• The [Minimum limit brightness] setting was turned on. Turn
the setting off.
1. Flick the Start screen to the left, and then in the App list, tap
[Settings] → [other settings].
2. Turn off the [Minimum limit brightness] switch.
Indicator
The indicator flashes in green and orange.
• The battery cannot be charged temporarily because the ambient
temperature is too low or too high. Leave the unit in an
environment of 10 °C to 35 °C (50 °F to 95 °F) for about an hour.
• The unit cannot turn on because the unit's temperature is -12 °C
(10.4 °F) or less. While the indicator flashes in green and orange,
the heater will try to heat the unit if it is enabled. Once the unit
warms up, the indicator will stop flashing and the unit will turn on
automatically.
The indicator lights in red.
• The remaining battery level is approximately 10 % or less of a full
charge. Charge the battery.
The indicator flashes in red.
• Battery authentication failed. Use a battery specified on page 58.
• There may be debris lodged in the battery charge terminals.
Remove the battery and remove any debris found.
48