JVC VS-DT2000 Service Manual page 11

Removing the power transformer
Remove the top lens.
Remove the bottom panel.
Remove the top panel.
Remove the CD mechanism assembly.
1. Disengage the wire clamp and tie band bundling
the wires of the power transformer.
2. Disconnect the wire from connector CN192 on the
power amplifier board.
3. Disconnect the wires from connectors CN191 and
CN194 on the main board.
4. Remove the two screws R and two washers
attaching the power transformer.
[Reference]
After connecting the wires, bundling them
using a wire clamp and tie band.
Removing the fan motor
(See Figs. 13 and 14.)
Remove the top lens.
Remove the bottom panel.
Remove the top panel.
Remove the CD mechanism assembly.
Remove the front panel assembly.
1. Disconnect the wire from connector CN181 on the
main board.
2. From the right side of the main body, remove the
two screws P attaching the fan motor.
[Reference]
After mounting the fan motor, treat the wire
from the fan motor as shown in fig. 13.
(See Fig. 13.)
Main board
Tie band
Wire clamp
CN191
CN194
CN192
CN181
Treat the wire from the fan motor.
Fig.13
Fan motor
P
Fig.14
VS-DT2000
Power transformer
Washers
R
Fan motor
Power amplifier
board
Bottom chassis
1-11