NOTE: When connecting the
LAN cable, make sure that you
attach the ferrite core* to the
cable. Follow the steps below:
1. Open the ferrite core.
2. Wind your LAN cable around
the core for one circle and close
the core, leaving 3 ~ 5 cm
between the core and the
connector end.
3. Plug the connector end with
the core to the notebook.
* Specification of the core
1.Case dimension: (L×W×H mm)
33.0 ± 0.5 × 23.5 ± 0.5 × 23.5 ± 0.5
2.Typical impedance:
125 ohm min. @ 25 MHz
230 ohm min. @ 100 MHz
NOTE: While connecting the
modem cable, plug the
connector end with the core to
the notebook.
My Presario – Getting Started
Left-Side View
1. USB Port (
The 4-pin Universal Serial Bus port is for connecting an USB
device. (See "Connecting an USB Device" in Chapter 4 for more
information.)
2. CD/DVD/CD-RW Drive Port (
This port is for connecting the external CD/DVD/CD-RW drive.
3. PC Card Slot (
Your notebook supports one PC Card. (See "Installing a PC Card"
in Chapter 4 for more information.)
4. RJ-45 Connector (
With the RJ-45 connector, the type 1 STP or category 5 UTP cable
can be connected to your notebook.
5. RJ-11 Connector (
With the RJ-11 connector, the normal telephone line can be
connected to your notebook.
6. IEEE 1394 Port (Only available on selected model)
3~ 5 c m
This port is for connecting an IEEE 1394 device.
Rear View
1. VGA Port
This 15-pin analog port is for connecting an external monitor.
2. Battery Pack
The battery pack supplies power to your notebook when external
power is not connected. (See Chapter 3 for more information.)
1
2
Figure 1-2. Left-Side View
)
)
)
)
1
Figure 1-3. Rear View
3
4
5
6
1
)
2
Getting Started 1-3
3