CAUTION: Keep the protection
card in the slot when no PC card
is installed.
Note: Do not make any
hardware change by yourself.
* Only available on specific
models.
My Presario – Getting Started
Follow these steps to insert a PC card:
1. Install the PCMCIA software.
2. Locate the PC card slot on the left side of the notebook.
3. A protection card is installed inside the PC card slot to serve as a
cover for the slot. This cover protects the slot against foreign
matters such as the dust and water. Before using a PC card, press
the eject button to remove the protection card.
4. Slide the PC card with its label facing up into the slot until the
eject button pops out.
5. To remove a PC card, press the eject button.
Figure 4-1. Installing a PC Card
Memory Upgrade
You could upgrade your notebook memory to a maximum of
192/256MB* by installing the Compaq approved memory module.
Please refer to your dealer for assistance to get the proper Compaq
memory module for upgrading.
Eject Button
Ej
B
System Expansion 4-3