HP Compaq Presario,Presario 80XL302 Setup Manual page 47

My Presario – Getting Started
Saving starts the time-out for the Suspend mode. If the notebook
remains in Standby mode until the time-out period for Suspend mode
has been reached, the notebook enters Suspend mode.
The Suspend mode is determined by the next item, "Suspend Data
to." It can be either Suspend-to-RAM or Suspend-to-File.
When Suspend-to-RAM mode is initiated, several system
subsystems go into standby or off mode so that system power will be
reduced further. The system will wake up from Suspend-to-RAM
mode when a key is pressed. "Resume On Time" and "Resume On
Modem Ring", if enabled in this submenu, can also wake up the
system from Suspend-to-RAM mode.
When Suspend-to-File mode is initiated, the system preserves all the
running application programs as a file in a "suspend-to-file partition"
on the hard disk and then turns off automatically.
The available options are Disabled, 1 Min, 2 Min, 5 Min, 10 Min, and
15 Min.
Suspend Data to
The "Suspend Data to" item defines the Suspend mode of your
system.
The available options are RAM and Disk.
Cover Close
The "Cover Close" item sets the notebook status when you close the
cover.
Descriptions of the available options are:
Options
Descriptions
Video Off The LCD screen will be off when you close the
cover.
CRT Display The display output will switch to the external CRT
monitor.
Suspend Either Suspend-to-RAM or Suspend-to-File is
initiated depending on the setting of the previous
item, "Suspend Data to".
Battery Low Warning Beep
This item sets if the system will alert you upon low battery capacity.
The available options are Enabled and Disabled.
VGA Activity
The "VGA Activity" item sets if obvious video activities (such as
screen savers) will prevent Power Management modes.
Setup Configuration Utility 5-9