System Board - HP Compaq Presario,Presario V6500 Maintenance And Service Manual

Disconnect the USB board cable (3) and the power connector board cable (4) from the USB/power
3.
connector board.
Remove the USB/power connector board.
4.
Reverse this procedure to install the USB/power connector board.

System board

Description
System board for use in computer models with Intel processors
System board for use only in computer models with AMD processors:
In full-featured models equipped with UMA graphics subsystem memory
●
In defeatured models
●
Before removing the system board, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Optical drive (see
b.
Switch cover (see
c.
72 Chapter 4 Removal and replacement procedures
Battery on page 42).
Hard drive on page 43)
Optical drive on page
Switch cover on page
51)
53)
Spare part number
446475-001 and
453770-001
449901-001
454167-001