Cleaning and user maintenance shall not be made by children • without supervision. General Safety Only a qualified person must install this appliance and replace • the cable. Do not operate the appliance by means of an external timer or • separate remote-control system. www.zanussi.com...
Always wear door or the window is opened. safety gloves. • Do not pull the appliance by the handle. • The kitchen cabinet and the recess must have suitable dimensions. www.zanussi.com...
Page 4
• This appliance is not connected to a device, – do not put water directly into the hot which evacuates the products of appliance. combustion. Make sure to connect the www.zanussi.com...
Page 5
• Keep children away when the grill is in use. Authorised Service Centre. • Do not put the oven shelf with food on the • Be careful when you remove the door from highest shelf level. the appliance. The door is heavy! www.zanussi.com...
Hob integrated ignition on the control knob Hob ignition on the spark gen- erator button Oven integrated ignition on the control knob Oven ignition on the spark gen- erator button Hob thermocouple Oven thermocouple Oven cleaning Enamel Catalytic Pan support Enamel Cast iron www.zanussi.com...
For roasting larger joints of meat and poultry. • Storage compartment The storage compartment is below the oven cavity. To use the compartment, lift the lower front door then pull it down. Before first use WARNING! Refer to Safety chapters. www.zanussi.com...
• For ignition with spark generator button push and hold the spark generator button . At the same time push the knob for the hob down and turn it counterclockwise to the maximum gas flow position . Release the spark generator button when burner lights. www.zanussi.com...
Do not put unstable or damaged pots on the burners to prevent from spill and injury. Cookware CAUTION! WARNING! Make sure that pot handles are not Do not put the same pan on two burners. above the front edge of the cooktop. www.zanussi.com...
Cleaning the spark plug Speak to your local Authorised Service Centre periodically to check the conditions of the gas This feature is obtained through a ceramic supply pipe and the pressure adjuster, if fitted. ignition candle with a metal electrode. Keep www.zanussi.com...
Keep the knob for the oven functions pushed for 15 seconds or less to let the thermocouple warm up. If not, the gas flow is interrupted. www.zanussi.com...
Turn the knob for the timer as far as it goes, then turn it to necessary time period. This function has no effect on the After the time period is completed, an acoustic operation of the appliance. signal sounds. www.zanussi.com...
Be careful when you use the turnspit. The forks and the spit are sharp. There is a risk of injury. WARNING! Use oven gloves when you remove the turnspit. The turnspit and the grill are hot. There is a risk of burns. www.zanussi.com...
• Use a deep pan for very fatty food to prevent • Your oven can bake or roast differently to the the oven from stains that can be permanent. appliance you had before. Adapt your usual settings (temperature, cooking times) and shelf positions to the values in the tables. www.zanussi.com...
• If you have nonstick accessories, do not remove the internal panel of glass clean them using aggressive agents, sharp- when the door is still assembled. edged objects or a dishwasher. It can cause damage to the nonstick coating. www.zanussi.com...
Page 18
2. Clean the glass cover. 3. Replace the lamp with a suitable 300 °C 6. Use a spatula made of wood or plastic or heat-resistant lamp. equivalent to open the inner door. Hold the 4. Install the glass cover. www.zanussi.com...
It takes too long to cook the The temperature is too low or too Adjust the temperature if neces- dishes or they cook too quickly. high. sary. Follow the advice in the user manual. www.zanussi.com...
Technical data For minimal distances for fitting check the table. Dimension Height 850 - 870 Width Depth Appliance class Other technical data Appliance category: II2H3B/P LPG: G30 (3B/P) 28-30 mbar www.zanussi.com...
Page 21
The gas pipe in the appliance has two endings. Use a fixed connections or use a flexible You can connect the gas supply to either one of stainless steel pipes in compliance with the them. The pipe that is not used must be www.zanussi.com...
Page 22
• the fastening clamps are not rusted, • expired term is not due. A. Gas connection end If one or more defects are visible, do not repair B. Natural Gas pipe holder the pipe, but replace it. C. LPG pipe holder www.zanussi.com...
Page 23
The model determines the position of the bypass screw A. 2. Carefully remove from the burner the thermocouple A. Next remove the spark plug B. Changing from natural gas to liquid gas 1. Fully tighten the bypass screw. 2. Put the knob back. www.zanussi.com...
Page 24
Changing from natural gas to liquid gas 1. Fully tighten the bypass screw. 2. Put the knob back. 3. Connect the appliance to the electricity. Changing from liquid gas to natural gas www.zanussi.com...
Page 25
2. Put the appliance on the sidewall on a clean and smooth surface. Place each foot into a separate hole, in the plinth, and rotate it counterclockwise. 2. Release the burner injector with a 7 mm socket spanner and replace it with a right one. www.zanussi.com...
Page 26
Return the product to your the packaging in applicable containers to local recycling facility or contact your municipal recycle it. Help protect the environment and office. human health and to recycle waste of electrical and electronic appliances. Do not dispose www.zanussi.com...