Advertisement

Quick Links

User Manual
GETTING
STARTED?
EASY.
ZCG94396XA
EN User Manual
Cooker
EG

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZCG94396XA

  • Page 1 User Manual GETTING STARTED? EASY. ZCG94396XA EN User Manual Cooker...
  • Page 2: Safety Information

    VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
  • Page 3 accommodation where such use does not exceed (average) domestic usage levels. Only a qualified person must install this appliance and replace • the cable. This appliance is intended for use up to an altitude of 2000 m • above sea level. This appliance is not intended to be used on ships, boats or •...
  • Page 4: Safety Instructions

    WARNING: Ensure that the appliance is switched off before • replacing the lamp to avoid the possibility of electric shock. If the mains power supply cable is damaged, it must be • replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard.
  • Page 5: Gas Connection

    GAS CONNECTION WARNING! Risk of fire and explosion • All gas connections must be made by a qualified person. • Before installation, make sure that the local • Fats and oil when heated can release flammable distribution conditions (nature of the gas and vapours.
  • Page 6: Internal Lighting

    • Make sure the flame does not go out when you • Keep the lid glass open, while the oven is in quickly turn the knob from the maximum to the operation (if applicable). minimum position. INTERNAL LIGHTING • Use only the accessories supplied with the appliance.
  • Page 7: Product Description

    PRODUCT DESCRIPTION GENERAL OVERVIEW Button for the turnspit Display Knob for the grill Knob for the heating functions Button for the lamp Knobs for the hob Heating element Lamp Turnspit hole Shelf positions COOKING SURFACE LAYOUT Auxiliary burner Steam outlet - number and position depend on the model Semi-rapid burner Semi-rapid burner...
  • Page 8: Before First Use

    BEFORE FIRST USE 2. Press the button to set the time of WARNING! Refer to Safety chapters. day. After approximately five seconds, the flashing stops and the display shows the time you set. INITIAL CLEANING PREHEATING Remove all accessories from the oven. Preheat the empty appliance to burn off the Refer to "Care and cleaning"...
  • Page 9: Burner Overview

    BURNER OVERVIEW A. Burner cap B. Burner crown C. Ignition candle D. Thermocouple (if applicable) TURNING THE BURNER OFF To put the flame out, turn the knob to the off position WARNING! Always turn the flame down or switch it off before you remove the pans from the burner.
  • Page 10: Hob - Care And Cleaning

    Diameter of cookware Diameter of cookware Burner Burner (mm) (mm) Triple Crown 160 - 260 Auxiliary 120 - 180 Rapid 160 - 240 ENERGY SAVING Semi-rapid 140 - 240 • If it is possible, always put the lids on the cookware.
  • Page 11: Oven Functions

    OVEN FUNCTIONS Oven function Application Off position The oven is off. MIN - Heat settings Range of temperature adjustment. 240°C Grilling To grill flat food in the middle of the grill. To make toast. Oven fan To thaw frozen food. To use the fan in combination with the gas oven burner ignite the gas oven and turn the knob for the grill clockwise to activate the fan.
  • Page 12: Oven - Clock Functions

    1. Open the oven door. Do not keep the knob for the oven 2. Ignite the grill burner. functions pushed for more than 15 • For manual ignition hold a flame near the seconds. If the oven burner does not grill burner holes.
  • Page 13 A. Support hook Put the shelf on the correct shelf position. Make B. Forks sure it does not touch the back wall of the oven. C. Spit WARNING! The maximum weight D. Handle permitted on the oven shelf is 24 kg. The support hook is installed in the top Avoid putting heavier food on the of the oven cavity.
  • Page 14: Oven - Hints And Tips

    6. Use the screws to tighten the forks. 12. Make sure that turnspit rotates. 7. Put the tip of the spit into the turnspit hole. 13. Close the oven door. Refer to "Product description" chapter. The turnspit does not stop if you open the oven 8.
  • Page 15: Cooking Tables

    COOKING TABLES Casseroles Food Quantity (kg) Temperature (°C) Time (min) Shelf position 2.5 - 4.0 45 - 50 Lasagna Cannelloni 2.5 - 4.0 45 - 50 Potato gratin 2.5 - 3.0 60 - 65 Macaroni oven 4.0 - 4.5 40 - 45 Kebab Hala 3.5 - 4.0 40 - 50...
  • Page 16 Pizza Food Quantity (kg) Temperature (°C) Time (min) Shelf position Thin 1.5 - 2.5 20 - 30 Thick 1.5 - 2.0 20 - 25 Calzone 1.5 - 2.5 30 - 35 1) Preheat the oven for 15 minutes. Cakes Food Quantity (kg) Temperature (°C) Time (min)
  • Page 17: Oven - Care And Cleaning

    Food Quantity (kg) Grill position Time (min) Shelf position Toast browning 1.0 - 1.2 max. 7 - 10 Toast Hawai 1.0 - 2.0 max. 15 - 20 1) Preheat the oven for 10 minutes. Revolving frying Food Quantity (kg) Grill position Time (min) Shelf position Sheep on...
  • Page 18 2. Lift and turn the levers on the two hinges till they stop (until you reach the pins). 4. Put the door on a soft cloth on a stable surface. 5. Use a screwdriver to remove the 3 screws from the bottom edge of the door.
  • Page 19: Replacing The Lamp

    When the cleaning is completed, install the glass Make sure the levers are in their panels and the oven door. To install the oven door, original position before closing the do the above steps in the opposite sequence. door. Make sure the slot in the hinge A rests on the edge of the hinge support B REPLACING THE LAMP before releasing the oven door.
  • Page 20 WHAT TO DO IF... Problem Possible cause Remedy There is no spark when you try The hob is not connected to an Check if the hob is correctly to activate the spark generator. electrical supply or it is con- connected to the electrical nected incorrectly.
  • Page 21: Service Data

    Problem Possible cause Remedy The display shows an error There is an electrical fault. Deactivate the oven with the code that is not in this table. house fuse or the safety switch in the fuse box and activate it again. If the display shows the error code again, contact the Cus- tomer Care Department.
  • Page 22 TECHNICAL DATA Voltage 220 - 240 V Dimension Frequency 50 - 60 Hz Width Appliance class Depth Dimension Height 850 - 870 OTHER TECHNICAL DATA Appliance category: II2H3B/P LPG: G30 (3B/P) 28-30 mbar Natural Gas: G20 (2H) 20 mbar BYPASS DIAMETERS BURNER Ø...
  • Page 23 GAS BURNERS FOR LPG G30 28-30 mbar NORMAL POW- REDUCED POWER INJECTOR MARK BURNER GAS RATE g/h ER kW 1/100 mm Triple Crown 290.9 101o Rapid 218.1 Semi-rapid 1.85 134.5 0.43 Auxiliary 0.95 69.1 0.35 Oven 261.8 Grill 181.8 GAS CONNECTION FLEXIBLE NONMETAL PIPES CONNECTION If you have an easy access to the connection, you WARNING! Before you connect the...
  • Page 24 You can find this plate in the bag WARNING! Before you replace the supplied with the appliance. injectors, make sure that the gas If the supply gas pressure is not constant or it is knobs are in the Off position. different from the necessary pressure, install an Disconnect the appliance from the applicable pressure adjuster on the gas supply...
  • Page 25 2. Carefully remove from the burner the Assemble the burner in a revers sequence. thermocouple A. Next remove the spark plug B. Replace the gas type sticker near the gas supply ramp with the one related to the new gas type. ADJUSTING THE MINIMUM GAS LEVEL ON THE OVEN BURNER 1.
  • Page 26 3. Assemble the burner in a reverse sequence. WARNING! Put the mains plug Before you fix the screw, make sure that the into the mains socket only if all burner is pushed correctly to the back panel. parts are back into their initial Test the grill injectors.
  • Page 27: Electrical Installation

    To install all the accessories, do the first step in the opposite sequence. 5. Tilt the cooker forward 30 degrees and repeat the previous step for the back feet. ELECTRICAL INSTALLATION WARNING! The manufacturer is not responsible if you do not follow the safety precautions from Safety chapters.
  • Page 28 WWW.ZANUSSI.COM/SHOP...

Table of Contents