Table of Contents
Advertisement
Maintenance and repair
Risk of fire, risk of injury!
from improper repairs. Switch off fuse or pull out mains plug.
Repairs may be performed by a qualified technician
(electrician) only.
Risk of injury!
from defective or damaged appliance. Switch off fuse or pull
out mains plug and call customer service.
Operating modes
This appliance can be used in exhaust-air mode or circulating-
air mode.
Exhaust air mode
The air which is drawn in is cleaned by the
grease filters and conveyed to the exterior by a
pipe system.
Note: The exhaust air must not be conveyed into a functioning
smoke or exhaust gas flue or into a shaft which is used to
ventilate installation rooms which contain heating appliances.
Before conveying the exhaust air into a non-functioning
■
smoke or exhaust gas flue, obtain the consent of the heating
engineer responsible.
If the exhaust air is conveyed through the outer wall, a
■
telescopic wall box should be used.
Operation
These instructions apply to several appliance models.
It is possible that individual features are described which
do not apply to your appliance.
Note: Switch on the extractor hood when you start cooking
and switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel variant 1
5HGXFH
2Q2II
IDQ VSHHG
6DWXUDWLRQ GLVSOD\âRII
Control panel variant 2
4
,QFUHDVH
IDQ VSHHGâ
,QWHQVLYH VHWWLQJ
'LVSOD\
)DQ UXQRQ
IDQ VHWWLQJV
Risk of fire, risk of injury!
from damaged connection cable. A damaged connection cable
must be replaced by a qualified technician (electrician).
Risk of burns, risk of electric shock!
from defective bulbs. Switch off fuse or pull out mains plug.
Always replace defective bulbs immediately (leave bulbs
to cool down first) to prevent the remaining bulbs from
overloading.
Circulating-air mode
Note: To bind odours in circulating-air mode, you must install
an activated carbon filter. The different options of operating
the appliance in circulating-air mode can be found
in the brochure or ask your dealer. The required accessories
are available from specialist outlets, from customer service
or from the Online Shop. The accessory numbers can be found
at the end of the instructions for use.
Setting the fan
Press the
■
at setting 2.
The fan can be set manually (model 1 and model 2) or
■
automatically (model 2 only).
Manual mode
Increase fan setting by pressing the + button and reduce it by
pressing the – button.
Automatic mode
/LJKW 2Q2II
The appliance must be switched on.
Press button
■
The optimum fan setting 1, 2 or 3 is automatically set via
■
a sensor.
Sensor control
In automatic mode sensors on the extractor hood detect
the density of the kitchen fumes. Depending on the setting
of the sensors, the extractor hood automatically switches
to another fan setting.
Factory setting: Setting
Lowest setting: Setting
Highest setting: Setting
If the sensor control responds too quickly or too slowly, it can
be changed accordingly:
When the fan is switched off, hold down button
1.
4 seconds. The setting is displayed.
The setting of the sensor control is changed by pressing
2.
the + or – button again.
To acknowledge the inputs, hold down the
3.
for 4 seconds.
The air which is drawn in is cleaned
by the grease filters and an activated carbon filter
and conveyed back into the kitchen.
%
button to switch on the appliance. The fan starts
.
)
†
‹
Š
for
)
button
)
Advertisement
Table of Contents
