Table of Contents
Advertisement
Intensive setting
You can use the Intensive setting for particularly strong odour
and fume generation.
Press the + button several times.
■
is indicated on the display.
›
■
The duration is limited. Then the fan is automatically reduced to
a lower setting. You can reduce the setting any time
by pressing the – button.
Switching on fan run-on
Press button
.
r
■
The fan runs for approx. 9 min at the selected fan setting.
Then the fan switches off automatically.
As long as
r
is lit, the run-on time can be changed. To do
■
this, press the – or + button.
The current run-on time can be displayed at any time by
pressing the
r
button or changed by pressing the –
or + button.
Light
The light can be switched on and off independently of the fan.
Press button
A
.
Setting the brightness
Hold down the
button until the required brightness
A
is obtained.
Installing and removing filter
ã=
Risk of burns, risk of electric shock!
from appliance. Always leave appliance to cool down before
cleaning or servicing. Switch off fuse or pull out mains plug.
Removing metal-mesh grease filter
Open lock and fold down the metal-mesh grease filter.
1.
In doing so, place other hand under the metal-mesh grease
filter.
Take metal-mesh grease filter out of the holder.
2.
Saturation displays
When the metal-mesh grease filters or the activated carbon
filter are saturated, a signal sounds for 4 seconds after the fan
is switched off.
In addition, the following symbol is indicated on the display:
Metal-mesh grease filter:
■
Activated carbon filter:
■
Now, at the latest, the metal-mesh grease filters should be
cleaned or the activated carbon filter changed.
While the saturation displays are flashing, they can be reset.
To do this, press the
#
button (model 1) or the – button
(model 2).
Switching over the display for circulating-air mode
For circulating air mode the electronic control display must be
switched over accordingly:
The extractor hood must be connected and switched off.
■
Simultaneously press the
■
Press the button combination
■
the electronic control display back to exhaust air mode
(display
).
#
Acoustic signal
When a button is pressed, an acknowledgement signal sounds.
Switching off the acoustic signal
When the fan is switched off, simultaneously hold down
buttons
and + for approx. 3 seconds.
%
An acknowledgement signal sounds.
Switching on the acoustic signal
Repeat the "Switching off the acoustic signal" process.
With edge extraction
Pull metal-mesh grease filter downwards.
1.
In doing so, place other hand under the metal-mesh grease
filter.
Take metal-mesh grease filter out of the holder.
2.
Notes
Grease can accumulate in the bottom of the metal-mesh
■
grease filter.
– Do not hold metal-mesh grease filter at an angle, otherwise
grease will drip out.
Installing metal-mesh grease filter
Insert metal-mesh grease filter.
1.
In doing so, place other hand under the metal-mesh grease
filter.
Fold up metal-mesh grease filter and lock.
2.
#
#'
and
buttons until
%
r
#'
%
und
r
to switch
is lit.
5
Advertisement
Table of Contents
