Advertisement
Installation Manual
■ Be sure to read this Instruction Manual before installation, and then properly install the product.
■ Installing this product requires the qualification as an electrical worker. Be sure to ask a contractor
Safety precautions
The precautions describe what must be observed not to harm humans nor cause property damage.
● Do not make any modification to this product.
Doing so will result in an electric shock, a fire, or a drop
● Do not use it at the place which dew
condensation generates by a quick temperature
change like the wind of an air-conditioner.
Doing so will result in an electric shock, a fire, or a drop
● Do not use it in places with combustion gas.
cause of the explosion.
● this product is dedicated to ordinary indoor use, Do not
use it at the place which is subject to the influence of heat,
such as the upper part of a heater, or a place with moist
place and vibration, which receives blowing in of rain, and
a moist,,where corrosive gas, where the smoke rises
・A place with moist place and vibration
・A place which receives blowing in of rain, and a
moist place
・A place where corrosive gas, where the smoke
rises
・ The place which is subject to the influence of
heat, such as the upper part of a heater
Not doing so will result in an electric shock, a fire, or a
drop.
● Do not install the Factory Line duct passing
through building structure
Doing so may result in a fire.
● Do not slide putting the plug in the duct
Poor contact will cause a fire.
● During construction,Do not give a shock, such as
dropping on a product, or hitting.
It may be damaged.
Factory Line 20
Be sure to observe the precautions fully
Warning
● Install this product in accordance with the Electrical Equipment Technical
Standards (Law) and the Internal Wiring Regulations. Use proper
overcurrent circuit breakers on the primary side ofpower supply. Choose a
size of cable used to supply power to Factory Line suitable for overcurrent
circuit breakers to protect the branch circuit and for the rated current.
Not doing so will result in an electric shock, a fire, or a drop.
● Before check for the product, be sure to turn OFF the
power supply.
Doing so may result in an electric shock .
● Make below the weight that can allow the weight hung to
the duct.
Not doing so will result in a drop.
Caution
● Use the range of －10 ℃ ～ 40 ℃ ambient temperature
The use with out of range, burn, or cause a fire.
● For cutting work, wear protective equipment such as
safety glasses.
Not doing so may cause you to injure your finger.
● After cutting, deburr edges using a file.
Not doing so may cause you to injure,so may result in a fire.
● When cutting the ducts, use a metal hacksaw(hand type)
and cut with the opening in the duct facing downward as
shown in the figure.
If a power saw is used, the insulation cladding or ground
terminals could be scraped or burned.
● When cutting the ducts, cut at right angles.
Not doing so will result in an electric shock, a poor contact.
● Do not mount the Factory Line 20 upward, when installing
the horizontal towards, Where there is no one easy touch
it (eg where more than 1.8 m) and duct cover (sold
separately) that must be used.
Failure to install a duct cover, causing a fire due to ingress of
dust.
● Insert the connecting component in a duct certainly and
tighten the set screw
Not doing so will result in an electric shock, a fire, or a drop.
● When connect the wires to the feed-in cap, insert the
electrical wires until they are visible in the peep hole.
Not doing so will result in an electric shock, a fire.
Advertisement
