Table of Contents
Advertisement
78K0R – Save It!
Then locate the sample project on the CD and open the SAMPLE-TK-78K0RKE3L.eww workspace file.
Afterwards the IDE should look similar like below.
To verify that the right debugging device is chosen please open the project options window by clicking
Options and then open the tab Debugger.
Project
Note: Although the On-board debug interface is used, the MINICUBE C-Spy driver must be selected
instead of the standard driver TK-78K used for other starter kits. If the debug session via
MINICUBE2 and the OCD1 connectors shall be started, also the MINICUBE C-Spy driver must
be selected.
The corresponding COM port where the TK-78K0R/KE3L board is connected to the host PC will be detected
automatically by the IAR C-SPY debugger.
_______________________________________________________________________________________________
Figure 33: IAR Embedded Workbench Main IDE window
U19663EE1V0UM00
User's Manual
37
Advertisement
Table of Contents
