Table of Contents
Advertisement
78K0R – Save It!
Figure 34: IAR Embedded Workbench Debugger Options
The next step is to check that the correct linker settings are set. This can be done in the "Linker" category as
shown below. Select the "Config" tab and check that the linker command file "lnk78f1009.xcl" is selected.
This file is used by the linker and contains information on where to place the different sections of code, data
and constants that may be used within the demo project:
_______________________________________________________________________________________________
U19663EE1V0UM00
User's Manual
38
Advertisement
Table of Contents
