Table of Contents
Advertisement
changing the receiver name
During setup, the receiver name defaults to "My
Receiver". You can either leave this name or change it
to something more meaningful, such as "Living Room"
or "Bedroom". The name is used when allowing access
to your servers, or when you are controlling more than
one media receiver on your network.
From the home screen, press the options button,
select Preferences and then Receiver Name. Use
the onscreen keyboard to edit the name.
controlling another receiver
You can control music playback on another receiver if
you have more than one media receiver on your
network. See "controlling music playback" on
page 28.
12
hp digital media receiver
screen saver
The screen saver will appear after two minutes of
inactivity. Press any button on the remote to exit the
screen saver.
The screen saver time-out can be changed. From the
home screen, press the options button, select
Preferences and then Screen Saver Delay.
Choose a delay from a minimum of15 seconds to a
maximum of 10 minutes.
Note:
If your TV is sensitive to screen burn-in, you
should reduce the screen saver delay to a minimum.
Consult your TV manual for recommended settings.
running the setup wizard
The setup wizard runs the very first time you setup your
hp digital media receiver. If you relocate the receiver
or wish to make changes to your settings, you can run
the setup wizard again.
From the home screen, press the options button, then
highlight and select Run Setup Wizard.
Advertisement
Table of Contents
