Bosch GLI 18V-1900 C Professional Original Instructions Manual page 10

OBJ_DOKU-54076-001.fm Page 10 Tuesday, July 12, 2016 4:06 PM
10 | English
The cordless worklight is dustproof and splash-protected due
to its special battery pack cover.
Bluetooth® enables the cordless worklight to be operated us-
ing the "Bosch Toolbox" application.
Product Features
The numbering of the product features refers to the illustra-
tion of the cordless worklight on the graphics page.
1 On/Off switch
2 Lock of the battery pack cover
3 Battery pack cover
4 Lamp head
5 Pedestal
6 Heat sink
7 Tripod mount 5/8"
8 Carrying handle
9 Screw for battery lid
10 Battery lid
11 Button cell (3 V lithium battery, CR 2032)
12 Battery pack*
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Cordless Worklight
Article number
Rated voltage
Lighting duration, approx.
Permitted ambient
temperature
– during charging
– during operation* and
during storage
Recommended batteries
Recommended chargers
Degree of protection
A) The signal range may vary greatly depending on external conditions,
including the receiving device used. The Bluetooth® range may be signif-
icantly weaker inside closed rooms and through metallic barriers (e.g.
walls, shelving units, cases, etc.).
* limited performance at temperatures <0 °C
** only for wireless charging batteries
*** applies only when battery pack cover is closed and locked
The colour rendition of illuminated objects can be distorted.
1 609 92A 2SA | (12.7.16)
Cordless Worklight
Data transmission
Bluetooth®
Signal range
A) The signal range may vary greatly depending on external conditions,
including the receiving device used. The Bluetooth® range may be signif-
icantly weaker inside closed rooms and through metallic barriers (e.g.
walls, shelving units, cases, etc.).
* limited performance at temperatures <0 °C
** only for wireless charging batteries
*** applies only when battery pack cover is closed and locked
The colour rendition of illuminated objects can be distorted.
System Requirements
Mobile terminal device
(tablet, smartphone)
Assembly
Battery Charging (Accessory)
Note: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without re-
ducing its service life. Interrupting the charging procedure
GLI 18V-1900 C
does not damage the battery.
3 601 D46 5..
The lithium-ion battery is protected against deep discharging
V= 14,4 18
by the "Electronic Cell Protection (ECP)". When the battery is
min/Ah 40 50
empty, the cordless worklight is switched off by means of a
protective circuit.
 Do not continue to press the On/Off switch after the
°C 0...+45
°C –20...+50
To remove the battery 12, press the battery unlocking button
GBA 14,4
2 and pull the battery toward the rear out of the cordless
GBA 18 V ...
worklight. Do not exert any force when doing this.
GBA 18 V ...W
Observe the notes for disposal.
AL 18..
GAL 3680
Operation
GAL 18...W**
IP 64 (dustproof
Initial Operation
and splash-
Inserting the battery
protected)***
Unlock the lock of the battery pack cover 2 and fold up the
battery pack cover 3.
Insert the charged battery 12 into lamp head 4 until it can be
felt to engage and faces flush against the lamp head 4.
Close the battery pack cover 3 and then the lock of the battery
pack cover 2.
 Make sure that the rubber lip is seated correctly when
Android 4.3 (and above)
iOS 9 (and above)
cordless worklight has been automatically switched
off. The battery can be damaged.
closing the battery pack cover. Otherwise protection
against dust and splash water will not be ensured.
GLI 18V-1900 C
Bluetooth® 4.1
(Low Energy)
A)
maximum 15 m
Bosch Power Tools