Advertisement
˜ Before use
˜ Unpacking
Remove the packaging . Check if the product is
damaged .
˜ Assembly
Accessory needed: Cross head screwdriver
Number of persons needed for assembly: 1 adult
Fig. Step
1 . Remove the knurled screw
pole on the motor unit
C
2 . Place the pole on the base
3 . Fasten with the knurled screw
Remove the 4 lock screws
D
unit
.
9 ]
[
1 . Align the rear grille handle
and to the rear . Attach the rear grille
E
to the motor unit
2 . Tighten with the 4 lock screws
1 . Place the blade
Insert the pins on the motor shaft into the
F
groove
on the rear of the blade .
3 ]
[
2 . Tighten the lock cap
(direction of rotation:
6 ]
[
10 GB/IE/NI
from the
[
14 ]
.
9 ]
[
.
[
13 ]
.
14 ]
[
from the motor
15 ]
[
upwards
[
5 ]
4 ]
[
.
[
9 ]
.
15 ]
[
on the motor shaft
[
2 ]
on the motor shaft
[
1 ]
) .
Fig. Step
1 . Remove the lock screw and the lock
nut
[
17 ]
2 . Loosen the grille clips
grille
3 . Centre the hanging device
G
grille
NOTE: The 4 grille clips
the frame of the rear grille
front grille
Insert and fasten the lock screw and the lock
nut
. Close the 4 grille clips
17 ]
[
frame of the rear grille
.
18 ]
[
H
NOTE: The lock screw and the lock
nut
17 ]
[
these fasteners .
˜ Tilt adjustment
Loosen the knob
.
Adjust the tilt angle manually .
[
6 ]
Tighten the knob
Do not perform the tilt adjustment when the
product is in operation .
from the front grille
[
18 ]
from the front
[
16 ]
.
18 ]
[
19 ]
[
on the rear grille
18 ]
[
[
4 ]
[
16 ]
[
4 ]
.
[
18 ]
16 ]
[
and the front grille
4 ]
[
are very small . Do not lose or drop
.
12 ]
[
again .
[
12 ]
.
of the front
.
must fit over
and the
over the
Advertisement
