Advertisement
The output frequency of
this video recorder (VCR)
is set at UHF channel 22.
If channel 22 is already
used by another TV
station, or if the picture is
distorted, you can
change the transmitter
channel of your VCR.
Stages 5~8 will show you
how to change the output
frequency of your VCR.
8
Your TV receives signals from the video recorder (VCR) like another TV station.
You have to select a channel number on your TV and tune it in so that you may watch video
tapes.
If you have used a SCART or AUDIO and VIDEO cables then your TV should already have
a dedicated video channel built into it, usually called AV.
Make sure that you have
correctly installed your
VCR as described earlier
in this book.
Press POWER to turn on
your VCR.
Turn on your TV.
Insert a pre-recorded
Tune this channel until
video tape into your VCR
the video picture is sharp
and press PLAY on the
and the sound is clear.
remote control.
Select a TV channel
number on which you
wish to watch videos.
Don't worry if you don't have
If you have used a SCART
a video-tape to play at this
or AUDIO and VIDEO cables
stage!
you will not have to tune your
If you switch your VCR on
TV, simply select the AV
and continue stages 3~4,
channel. The AV channel is
instead of seeing video
already pre-tuned for opti-
playback tune your TV until
mum video playback on your
you see a bright blue
TV
screen.
REW
FF
PLAY
REC/
QSR
Store this channel on
your TV.
You will need to look at the
TV instruction book if you do
not know how to do this.
.
D
OK i
Advertisement
