Table of Contents
Advertisement
Available languages
Available languages
English
•
DO NOT use a USB cable with a damaged cord or plugs. Have them
replaced immediately.
•
Foreign materials of a conductive nature, such as, but not limited to, grinding dust,
metal chips, steel wool, aluminum foil or any buildup of metallic particles should be
kept away from the USB and micro USB plugs and port.
•
Always unplug the USB cable from the power supply when there is no tool
attached to it.
Charging Procedure (Fig. B)
WARNING: Do not use tool while it is connected to the charger.
1. Insert the charging cable
2. Plug the other end of the charging cable into any compatible port (such as on a computer).
The green charging LEDs
‑
One will flash with a low charge.
‑
Two will flash with a medium charge .
‑
Three will flash with a high charge.
‑
All LEDs will remain on when tool is fully charged.
3. Battery can be left charging or charger can be disconnected.
Electronic Protection System
Li‑Ion tools are designed with an Electronic Protection System that will protect the battery
against overloading, overheating or deep discharge. The tool will automatically turn off and
the battery will need to be recharged.
Important Charging Notes
1. The tool may become warm to the touch while charging. This is a normal condition, and
does not indicate a problem. To facilitate the cooling of the tool after use, avoid placing
the tool in a warm environment such as in a metal shed or an uninsulated trailer.
2. If the tool does not charge properly, take the tool to your local service center.
3. You may charge a partially used battery whenever you desire with no adverse effect on
the tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal injury, turn unit off and lock
the trigger before making any adjustments or removing/installing attachments
or accessories. An accidental start‑up can cause injury.
10
10
into the charging port
7
will flash.
8
.
Advertisement
Table of Contents
