How Do I Configure The Netcom; Installing The Netcom Utilities; Configuring The Netcom; Hyperterminal Setup Example (Serial Cable) - Mitsubishi Electric Netcom 2 User Manual

Table of Contents

Service Pack 2 is installed on a computer it will turn on the personal firewall. Below are

the steps to open up the web port for Netcom in Windows XP Firewall:

  S elect Start Menu > Control Panel.

  S elect Network Connections and right click on the connection that is

being used.

  C lick on Properties and click the Advanced tab in the Properties

dialogue.

  P ress the Settings... button to bring up the Firewall dialogue.

  G o to the Exceptions tab and click the Add Port button.

 F or Name enter Netcom Web Port and for Port Number enter 80. Press the OK

button.

 Y ou now will be able to access the Netcom web port through the Windows XP

Firewall.

4. How do I Configure the Netcom?

4.1 Installing the Netcom Utilities

The Netcom CD contains the following:

  S NMP MIB

  N etcom User Manual (PDF)

  S hut down installation procedure

  N etcom FAQ

 Firmware

To install the Netcom Utilities or access any of the documents, place the Netcom CD in

the CD

drive. The Netcom Utilities CD should automatically start. Follow the instructions

provided on

your screen.

The initial network settings can be made by connecting the Netcom to a serial

communication program using the included configuration cable or cross over cable and

laptop.

1. Connect the 9 pin connector to the PC and the 9 pin receptacle labeled "Serial

RS232" on the Netcom.

SVA026 Netcom 2 User Manual ver5

Table of Contents