2-1. BOARDS LOCATION
2-2. PRECAUTION IN WIRING HARNESS
. The harness inside the WRR-800A are laid out so that they are not positioned close to the heat-producing parts or high
voltage present parts by routing the harnesses properly or using purse locks.
Therefore, when the boards are replaced (or parts are replaced), be sure to return the harnesses to their original locations
(see the following illustration).
. When replacing a board (or when replacing a part), turn the POWER switch OFF , and unplug the power cord from the
AC inlet.
WRR-800A
SECTION 2
SERVICE OVERVIEW
MB-786
CN-1598
RE-157
Tuner Uniit
VR-245
2-1