5.3.3
Jumper pin assignment
There are four jumper settings as shown in the following sections:
•
16 logical head default (normal use)
•
15 logical head default
•
32 GB clip
•
Power up in standby
Within each of these four jumper settings the pin assignment selects Device 0, Device 1, Cable Selection,
or Device 1 Slave Present as shown in the following figures.
The Device 0 setting automatically recognizes device 1 if it is present.
The Device 1 Slave Present setting is for a slave device that does not comply with the ATA specification.
Note: In conventional terminology "Device 0" designates a Master and "Device 1" designates a Slave.
RSV
I
Figure 49. Jumper pin assignment
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1)
GND
GND
G
E
F
H
DS
CS/SP
36
GND
RSV
C
A
D
B
GND
RS V