Figure 22 Jumper Settings For Disabling Auto Spin - Hitachi CinemaStar P7K500 Specifications

5.3.4.4
Power Up In Standby
The figure below shows the jumper positions used to select Device 0, Device 1, Cable Selection, or Device
1 (Slave) Present to enable Power Up In Standby.
I G
H
I
G
H
I
G
H
I
G
H

Figure 22 Jumper settings for Disabling Auto Spin

Notes:
1. These jumper settings are used for limiting power supply current when multiple drives are used.
2. Command to spin up is SET FEATURES (subcommand 07h). Refer to 10.37 Set Features.
3. To enable the CSEL mode (Cable Selection mode) the jumper block must be installed at E-F.
In CSEL mode, the drive address is determined by AT interface signal #28 as follows:
•
When CSEL is grounded or at a low level, the drive address is 0 (Device 0).
•
When CSEL is open or at a high level, the drive address is 1 (Device 1).
HITACHI Deskstar & CinemaStar P7K500 Hard Disk Drive specification (Rev 1.1)
E C A
DEVICE 0 (Master)
F D B
E C A
DEVICE 1 (Slave)
F D B
E C A
CABLE SEL
F D B
E C A
DEVICE 1 (Slave) Present
F D B
40