Table of Contents
Advertisement
2.
Install the 5 weights under the weight tray
(Figure
2).
Figure 2
1. Nut (2)
2. Weight tray
3.
Install the plate at the front of the weight tray
(Figure
3).
Figure 3
1. Plate
4.
Install the suitcase weight behind the plate and
install the retaining rod
g305331
3. Weight (5)
4. Carriage bolt (2)
g305330
(Figure
1).
3
Installing the Lower Tubes
and Seat Belt
Parts needed for this procedure:
1
Left lower roll bar
1
Right lower roll bar
4
Bolt (1/2 x 4 inches)
6
Washer
6
Locknut (1/2 inch)
1
Left support bracket
1
Right support bracket
2
Bolt (1/2 x 1-1/4 inches)
2
Bolt (1/2 x 1-3/4 inches)
Procedure
Note:
The engine and left and right pods are not
shown in the figures.
1.
Raise and support the machine so that the rear
wheels are off the ground.
2.
Remove the rear wheels.
3.
Loosely install the left and right lower roll bar
tubes using 2 bolts (1/2 x 4 inches), 2 washers,
and 2 locknuts (1/2 inch) for each tube
4).
Note:
Ensure that the battery cables route
between the right pod and the right roll bar.
4
(Figure
Advertisement
Table of Contents
