Table of Contents
Advertisement
Machines with MyRide
Install the seat-belt assembly and buckle to the seat
as shown in
Figure
9.
•
For seats with a welded nut, use 2 bolts (7/16 x
1-1/4 inches). Torque the bolts to 68 N∙m (50 ft-lb).
•
For seats without a welded nut, use 2 bolts (1/2 x
1-1/4 inches) and 2 locknuts (1/2 inch). Torque the
bolts to 102 N∙m (75 ft-lb).
1. Seat-belt assembly
2. Bolt
5
Installing the Roll Bar
Parts needed for this procedure:
1
Roll bar
4
Side plate
8
Bolt (1/2 x 3 inches)
4
Flat spacer
6
Washer
8
Locknut (1/2 inch)
3
Bumper
4
Cylindrical spacer
1
Lanyard with pivot pin, washer, and hairpin cotter
Procedure
Note:
Leave the bolts loose enough so that the parts
are free to shift around.
1.
Install 2 side plates to both sides of the roll bar
using 3 bolts (1/2 x 3 inches), 2 flat spacers, 3
washers, 1 cylindrical spacer, and 3 locknuts
(1/2 inch) on each side
Figure 9
3. Locknut (seats without
welded nut only)
4. Seat-belt buckle
(Figure
10).
g388437
1. Bolt—1/2 x 3 inches (3)
2. Washer (3)
3. Side plate (2)
4. Flat spacer (2)
2.
Install a bumper in the center of the roll bar
(Figure
10).
3.
Install a bumper and cylindrical spacer to both
lower roll bar tubes
1. Cylindrical spacer
4.
With the assistance of a second person, attach
the roll bar assembly and the lanyard washer
to the lower roll bar tubes using a bolt (1/2 x
3 inches) and locknut (1/2 inch) on each tube
(Figure
12).
7
Figure 10
5. Roll bar
6. Bumper
7. Locknut—1/2 inch (3)
8. Cylindrical spacer
(Figure
11).
Figure 11
2. Bumper
g222814
g222812
Advertisement
Table of Contents
