Sony DCR-SR32E Manual page 23

Ver. 1.7 2008.04
4. CAMERA Adjustment 2
(Using the minipattern box or flange back adjust-
ment jig)
[Automatic Adjustment Program execution items and
sequence]
1. Data Setting during Camera Adj.
2. Flange Back Adj.
3. Release of Data Setting during Camera Adj.
[Preparation (Using the minipattern box)]
1) The minipattern box is installed as shown in the following fig-
ure.
Note: The attachment lenses are not used.
2) Install the minipattern box so that the distance between it and
the front of lens of camera is less than 3 cm.
3) Make the height of minipattern box and the camera equal.
4) Check the output voltage of the regulated power supply is the
specified voltage ± 0.01 Vdc.
5) Check that the center of Siemens star chart meets the center of
shot image screen with the zoom lens at TELE end and WIDE
end respectively.
Specified voltage: The specified voltage varies according to the
Red (+)
Black (–)
Yellow (SENS +)
White (SENS –)
Black (GND)
DCR-SR32E/SR33E/SR42/SR42A/SR42E/SR52E/SR62/SR62E/SR72E/SR82/SR82C/SR82E_ADJ
minipattern box, so adjustment the power sup-
ply output voltage to the specified voltage writ-
ten on the sheet which is supplied with the
minipattern box.
Below 3 cm
Minipattern box
Regulated power supply
Output voltage : Specified voltage ± 0.01 Vdc
Output current : more than 3.5 A
Need not connected
Fig. 6-1-12
[Preparation (Using the flange back adjustment jig)]
(Illuminance: 950 to 1050 lux)
Note 2: When using the flange back adjustment jig, take care of
the following points:
• For the illumination, use a light source such as an in-
• Do not make an adjustment in the environment where
1) Install the flange back adjustment jig so that the distance be-
tween it and the front of lens of camera is less than 3 cm.
2) Make the height of flange back adjustment jig and the camera
equal.
3) Check that the center of chart meets the center of shot image
screen with the zoom lens at TELE end and WIDE end respec-
tively.
Flange back adjustment jig
Camera
[Adjusting method]
1) Click the [Start] button of the CAMERA Adjustment 2.
2) The Automatic Adjustment Program executes "1. Data Setting
during Camera Adj.".
3) Upon successful completion of the "1. Data Setting during
Camera Adj.", the following message is displayed. Set the sub-
ject by referring to "Preparation".
4) If the [OK] button is clicked, "2. Flange Back Adj." and "3.
Release of Data Setting during Camera Adj." will be executed.
5) Upon successful completion of all items of the CAMERA
Adjustment 2, the following message is displayed. Click the
[OK] button.
6-21
candescent lamp or inverter type fluorescent light free
from flickering.
fluorescent lamp flickering occurs even if the illumi-
nance can be ensured with the room illumination only.
Use an incandescent lamp or inverter type fluorescent
light at a place free from the influence of room illumi-
nation.
Fig. 6-1-13
Below 3 cm
Camera