Sharp DV-500D Technical Manual page 30

DVD-Series
5-6 Tray 1 Reverse Action
(1) While Tray 1 is inserted, start the Tray 1 discharge action via operating keys. After the Brake
Mode has been on for 150msec, start the loading motor in low-speed mode for reverse, then
move the tray to the Tray 1 "open" position.
(2) While Tray 1 is discharged, start Tray 1 insert action via operating keys.
After the Brake Mode has been on for 150msec., start the loading motor in low-speed forward
mode, then move the tray to the Tray 1 "close" position.
5-7 Tray 2 Insert Action
While Tray 2 is "open", start the Tray 2 insert action via key operation or by detecting SW1B input
rise. Start the loading motor with high-speed mode for reverse rotation, then change it to low-speed
mode for forward rotation 1.2 second after the detection of the rise of SW1B. c:then, move it to
the Tray 2 "close" position.
If the insert action is not completed in 6 seconds, it stops once and begins reverse discharge action.
5-8 Tray 2 Discharge Action
While Tray 2 is "close", start the Tray 2 discharge action via key operation. Start the loading motor
with high-speed mode for forward rotation, then change it to low-speed mode for forward rotation
1.2 second after the detection of the rise of SW1A. a:then, move it to the Tray 1 "open" position.
If the discharge action is not completed in 6 seconds, it stops once and begins reverse insert action.
5-9 Tray 2 Reverse Action
(1) While Tray 2 is inserted, start the Tray 2 discharge action via operating keys. After the Brake
Mode has been on for 150msec, start the loading motor in low-speed mode for forward, a:then
move the tray to the Tray 2 "open" position.
(2) While Tray 2 is discharged, start Tray 2 insert action via operating keys.
After the Brake Mode has been on for 150msec., start the loading motor in low-speed reverse
mode, c:then move the tray to the Tray 2 "close" position.
5-10 PICKMECHA Moving Action from the Tray 1 to the Tray 2
side
With Tray 2 "closed" (or when PICKMECHA has finished moving from the Tray 2 side to the Tray
1 side), start the moving action of PICKMECHA from Tray 1 side to the Tray 2 side by key
operation.
Start the loading motor under high-speed mode. After 1.2 second from detection of the rise in
SW1A input, set reverse low-speed mode, d: then move PICKMECHA to the end position from
the Tray 1 to the Tray 2 side.
30