Toro Groundsmaster 3200 Series Installation Instructions Manual page 6

Figure 16
1. Top view
2. Cutaway (side) view
6. Remove the backing film from the bottom side of
the upper brake-cover foam
7. Install the lower brake-cover foam onto the
upper brake-cover foam
16).
8. If the optional USB charging kit is installed,
perform the following steps:
A. Install the USB port into the brake cover.
B. Connect the 2 wire terminals of the machine
harness to the USB port.
9. Install the brake cover with the 2 previously
removed push-in fasteners
g331283
3. Upper brake foam
(PSA—both sides)
4. Lower brake foam
(Figure 15).
(Figure 15 and Figure
(Figure 13).
Installing the Firewall Pads
1. Remove the backing film and install the
lower-firewall pad
1. Lower-firewall pad (PSA)
2. Remove the backing film and install the
upper-firewall pad
3. Remove the backing film and install the firewall
tile pad (Figure
1. Rear-window pad (PSA)
6
(Figure 17).
Figure 17
2. Upper-firewall pad (PSA)
(Figure 17).
18).
Figure 18
2. Firewall tile pad (PSA)
g330760
g330759