R E A R P A N E L - Kenwood FC-758 Instruction Manual

s w i t c h @ .
The G A T E L E D is provided to indicate the
counter is currently active.
If the s w i t c h is pressed, a new display resolution
value is selected. T h i s occurs every time when the
s w i t c h is pressed. There are four display resolution
values a v a i l a b l e . They are :
0.01s, 0.1s, 1s, 10s for Channel A
0.027s, 0.27s, 2.7s, 27s for Channel B
0.027s
Resolution Resolution
value value
0.01s
x l
Magnification
0.27s 2.7s
27s
0.1s 1.0s 10s
x l O X100
X1000
4 - 2 Rear Panel (See Figure 2.)
© T O T A L I Z E I N P U T S T A R T / S T O P Input juck
The T O T A L I Z E I N P U T S T A R T / S T O P input juck is
provided to control the event input count
mode.
The event input count operation is enabled if the
input signal to t h i s juck becomes active ( T T L level:
' H ' ) .
The event input count operation is forced to
terminate if the input signal to this juck becomes
inactive ( T T L level : ' L ' ) . The event input count
operation is also disabled if this juck is grounded
to the chassis ground.
operation
13