Advertisement
Connecting the appliance
Use the following instructions to connect the appliance to your
network.
For a diagram of the appliance, refer to
panels
on page 12.
For rack mounting instructions, refer to
appliance
on page 37.
To connect the SMA6200/7200 appliance:
1
Connect a network cable from your internal network to
the internal interface on the appliance (X0).
2
Optionally, connect a cable from your external network
to the external interface on the appliance (X1).
Starting the appliance
The SMA 6200 contains a single AC power supply and comes
with a single power cord. The SMA 7200 includes dual power
supplies for redundant AC power and added reliability. Two
power cords are included with the SMA 7200 appliance. Refer
to
Safety and regulatory information
information.
The included power cord(s) are approved for use only in
specific countries or regions. Before using a power cord, verify
that it is rated and approved for use in your location.
24
Dell Secure Mobile Access 6200/7200 Getting Started Guide
SMA 6200/7200 front
Rack mounting the
on page
45
for
To connect the power of the SMA 6200, plug in the power cord
to the power supply socket on the back of the appliance, and
then connect the cord to an AC outlet.
For the SMA 7200, plug the power cords to the power supply
sockets on the appliance back and then connect the cords to
AC outlets. For best reliability, connect the two cords of the
SMA 7200 to outlets on different circuits.
隨附的電源線僅限於特定的國家或地區使用。 使用前， 請確認
電源線的額定 且已被認可在你的地區上使用。
CAUTION:
Remove any USB devices from the appliance
before you reboot it. If a USB device is plugged in to
your appliance when it is rebooted, the appliance
tries to use it as a boot device. As a result, the boot
information stored in the BIOS on the appliance is
overwritten, and the device becomes unusable.
Entering network settings using
the LCD
Before you can run the Setup Wizard, you must first enter
basic network settings so that you can use a Web browser to
connect to the appliance. The LCD screen on the front bezel is
used for this part of the initial configuration.
Advertisement
