Advertisement
To access the login page after the Setup Wizard finishes, point
your browser to
https://<IP address>:8443
where <IP address> matches the address you defined for
the internal network interface. The default X0 IP address is
192.168.0.10.
Figure 2. AMC login screen
Type admin in the Username field, and then enter the
password you created with the Setup Wizard. Both are case-
sensitive. Click Login to log into the Management Console.
Configuring basic WorkPlace
portal access
For access from the WAN, you need an authentication server, a
realm, a user, and an access rule.
This section describes how to configure a local authentication
server and user on the appliance itself, and create a realm and
access rule to go with them. This allows you to quickly create
a portal while gathering the information needed for a full
production deployment.
This same sequence of steps also applies if you are configuring
an external authentication server and more advanced settings
for your realm or access rules.
Creating a local authentication server
To create a local authentication server:
1
In AMC, navigate to the System Configuration >
Authentication Servers page.
2
In the Authentication servers section, click New.
3
In the User Store section, under Local user storage,
select the Local users radio button.
4
Click Continue.
Dell Secure Mobile Access 6200/7200 Getting Started Guide
27
Advertisement
