HP 11793A Operating And Service Manual page 14

Model 11793A Microwave Converter
1
I
Not installed Standard
Option 010 Option 020
installed
Option 001
Option 011
Option 021
6. Options and Accessories
Electrical Options
The options are summarized in Table 3. The following list describes each option:
Option 001.
Option 010.
Adds an 18 to 26.5 GHz LO amplifier t o the standard instrument.
Moves the LO INPUT to the right side of the front panel.
Option 011.
Moves the LO INPUT to the right side of the front panel and adds the 18 to 26.5 GHz
LO amplifier.
Option 020.
Moves all front-panel connectors to the rear panel.
Option 021.
Moves all front-panel connectors to the rear panel and adds the 18 to 26.5 GHz LO
amplif ier.
Table
3.
HP
11
793A Option Guide
Front-Panel Placement Rear Panel
of LO Input
Placement for
I
Len Side Right Side
All Connectors
LO
Amplifier
Mechanical Options
Instruments with Serial Prefix 2407A have System 11 cabinet parts and hardware that are English thread.
Instruments with Serial Prefix 2520A and higher have System
I1
cabinet parts and hardware that are
METRIC thread.
When ordering Option 907, 908, or 909 for instruments with serial number prefix 2407A (English
thread), use the HP part number in parenthesis.
Option
907
(Front-Handle Kit). Ease of handling is increased with front-panel handles. To retrofit a
standard instrument, order HP part number 5061-9688 (5061-0088).
Option
908
(Rack-Flange Kit). All necessary hardware and installation instructions are included t o
enable mounting of the Microwave Converter in a rack with 482 mm (standard 19 in.) spacing. To retrofit
a standard instrument, order HP part number 5061-9674 (5061-0074) which has standard 4.45 cm (1.75
in.) hole spacing.
Option
909
(Rack-Flange and Front-Handle Combination Kit). This kit is not simply a front-handle kit
and rack-flange kit packaged together. The combination is made up of unique parts which include both
functions. To retrofit a standard instrument, order HP part number
SO6
1-9675
(SO6
1-0075) which has
4.45 cm (1.75 in.) hole spacing and is a standard flange.