Logitech BCC950 Quick Reference Manual

LOGITECH BCC950 CONFERENCE WEBCAM SET-UP
QUICK REFERENCE GUIDE V1
The Logitech BCC950 is NOT a stand-alone unit and will need to connect to a laptop or PC via a USB cable and an AC
power outlet. The 4 main components which comprise the BCC950 are shown below:
This is the
This is the base unit,
This is the eye-
The power supply
webcam
which connects via
level stand for the
plugs into the
USB to the computer
webcam
base unit
Together, these components can be used in either base mode, or extended to eye-level:
This is the
This is the
webcam with
webcam fitted
the eye-level
to the base unit
stand fitted
SETTING UP THE UNIT
Power on the laptop or computer you will be using with the webcam.
.
Connect the base
Attach the Webcam
Connect the power supply
Attach the
unit to the computer
to the Base Unit
to the rear socket of the
stand if required
with the USB cable
base unit and an AC outlet
Note:
if you wish to use the eye-level stand, you MUST disconnect the AC power BEFORE attaching or removing the
webcam. You can now launch the video conferencing software on the computer.
Please ensure the stand is fitted using the correct orientation, as shown below:
Top Stand Connector: Bottom Stand Connector:
© The content of this document is the copyright of Nottinghamshire Health Informatics Service (NHIS). Unless stated otherwise, you may only use this material for your
personal use, private study, research or in-house use. You must not copy, distribute or publish any material produced by NHIS unless formal permission is obtained
from the copyright holder