Assembly; Preparing Ingredients - Silvercrest SSM 200 A1 Operating Instructions Manual

Assembly

1) Remove all packaging materials and any
stickers from the appliance .
2) Clean the appliance as described in the
section "Cleaning and Care" .
3) Place the motor unit 0 on a flat surface .
4) Push the blade roller 5 into the roller
housing 3 . The drive shaft 4 must project into
the opening of the roller housing 3 .
5) Screw the end cap 8 onto the roller housing 3,
until the outlet 9 is pointing downwards and
the end cap 8 no longer turns . In doing so, turn
the end cap 8 in a clockwise direction, as
indicated on the roller housing 3:
6) Push the assembled roller housing 3 into the
motor unit 0, so that the feed tube 2 is
slightly offset (see figure B on the fold-out
page) . The arrow on the roller housing 3 must
point to the symbol on the motor unit 0 .
The catches on the roller housing 3 must grip
into the recesses on the motor unit 0 . Turn the
roller housing 3 so that the feed tube 2 is
pointing upwards, the arrow on the roller
housing 3 is pointing to the
motor unit 0 and the roller housing 3 clicks
into place (see figure C on the fold-out page) .
7) Place the pusher 6 into the feed tube 2 .
SSM 200 A1
NOTE
► The pusher lid 7 can be removed .
For removal:
–
For set up:
–
8) Insert the plug into a mains power socket .
.
The appliance is now ready for use .

Preparing ingredients

CAUTION! MATERIAL DAMAGE!
► Do not process fruits with stones or cores .
► Do not process whole nuts .
► Do not process ice cubes .
♦ Peel fruits such as bananas or kiwis .
symbol on the
♦ Remove cores, stones or stems from the fruit .
♦ Cut the fruit into small pieces so that it will easily
fit through the feed tube 2 .
♦ Ingredients such as such as cooking chocolate
must be crushed into small pieces .
♦ Put the prepared fruit in freezer bags or plastic
tubs and place them into the freezer for
approximately 24 hours (–18 °C) .
NOTE
► Instead of freezing fresh fruit, you can use fruit
that has already frozen from the deep-freezer .
Turn the pusher lid 7 anticlockwise until it
allows itself to be removed .
Place the pusher lid 7 on the pusher 6,
so that both locking mechanisms on the
pusher lid 7 slide through the slots on the
pusher 6 and then turn the pusher lid 7
in clockwise direction so that it is firmly held
in place .
GB │ IE │ 15 ■