JVC XA-GC20BK Instructions Manual page 25

Audio guidance system, portable rom player, infrared address transmitter, charger
Hide thumbs Also See for XA-GC20BK:
Table of Contents

Advertisement

Problem
The infrared beam
projection range is
extremely short.
Transmission area
is too small.
Does not operate.
Cannot recharge
the Portable ROM
Player.
Note
• JVC is not responsible for any lost revenues or
damages incurred due to the improper operation or
malfunctioning of these products. This should be
fully understood in advance before attempting to
use these products.
• Many of the functions of the Portable ROM Player
are executed with the use of micro processors. In
the event that the unit does not operate properly
due to for example static electricity, turn the POWER
to OFF. Then after a short while, turn back to ON.
Possible Cause
• Optical transmission lens on the
transmitter or the sensor lens on
the Portable ROM Player is dirty.
• Extremely strong rays or natural
sunlight shining in the direction
of the Portable ROM Player are
interfering with sensor
reception.
• An invertor fluorescent light has
been placed too close to the
transmitter and is shining in the
direction of the Portable ROM
Player.
• Installation angle of the
transmitter has slipped or was
not set properly.
• The set address and the CF card
WAV file do not match.
• Wrong CF card was inserted.
• Power cord is not plugged in
properly.
• Portable ROM Player and
charger terminals are dirty.
• Fuse has blown.
Solution
• Clean the optical
transmission lens on the
transmitter or the sensor
lens on the Portable ROM
Player.
• Place a blind to cover the
region of the window where
the sunlight enters.
• Place the transmitter away
from that type of fluorescent
light. Or replace the light
with a more common type of
fluorescent light.
• Install the transmitter
correctly after referring to
the examples that illustrate
the Pointing method and the
Auto method.
• Set the correct address.
• Insert the correct CF card.
• Plug the power cord
completely into the outlet.
• Clean both terminals used
for recharging.
• Replace the fuse with a new
one.
(Use 250V/5A fuse.)
Reference
page
page 10
|
page 13
page 7
page 22
page 5
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xa-gp1bkXa-gt1tn

Table of Contents