Advertisement
Removing the Mechanism P.C. Board
Reference:The mechanism P.C. board can be
removed without removal of the
TRAMECHA assembly.
Note: Before disconnecting the flexible wire coming
from the pickup from the connector, be sure to
solder its shorting round.
If the flexible wire is connected without
soldering, it may cause breakdown of the
pickup.
1. Solder the shorting round of the flexible wire
connected with the mechanism P.C. board from the
back of the mechanism assembly.
2. Disconnect the flexible wire from the connector
CN601 on the mechanism P.C. board.
3. Remove the three screws C fastening the
mechanism P.C. board.
4. Unsolder the two points of the part h and one point
of the part i of the mechanism P.C. board. Then,
remove the mechanism P.C. board upwards.
Note: When reinstalling the mechanism P.C. board,
connect the flexible wire coming from the
pickup to the connector first and then remove
the solder from the shorting round of the
flexible cable.
(Refer to Fig 10.)
Soldered
part h
Flexible wire
C
C
Soldered part i
Fig. 10
NX-HD10
Shorting round
CN601 on
mechanism
P.C. board
C
1-17
Advertisement
